Sunday, March 29, 2015

FLEX SENSOR



INTRODUCTION

The Flex Sensor patented technology is based on resistive carbon elements. As a variable printed resistor, the Flex Sensor achieves great form-factor on a thin flexible substrate. When the substrate is bent, the sensor produces a resistance output correlated to the bend radius—the smaller the radius, the higher the resistance value.


FEATUTRES

  • Size: approx 0.28" wide and 1"/3"/5" long
  • Resistance Range: 1.5-40K ohms depending on sensor. Flex point claims a 0-250 resistance range.
  • Lifetime: Greater than 1 million life cycles
  • Temperature Range: -35 to +80 degrees Celsius
  • Hysteresis: 7%
  • Voltage: 5 to 12 V

APPLICATION

  • gaming gloves
  • auto controls
  • fitness products
  • measuring devices
  • assistive technology
  • musical instruments and joysticks

SPECIFICATION

 parameter
 value
Operating Voltage
+5V DC regulated
Operating Current
100mA
Output
 Analog output
Flex Bending
Nominal,45 degree,90 degree


PIN DETAILS

Board has 3-pin connector for using the sensor. Details are marked on PCB.

Pin
Name
Details
1
GND
Power Supply Ground
2
+5V
Power supply Positive input
3
OUT
Analog output


USING SENSOR

  • Connect regulated DC power supply of 5 Volts. Black wire is Ground, Next middle wire is Brown which is output and Red wire is positive supply. These wires are also marked on PCB.
  • To test sensor you only need power the sensor by connect two wires +5V and GND. You can leave the output wire as it is.
  • The flex sensor analog resistors. They work as analog voltage dividers.
  • When the substrate is bend the sensor produces resistance output relative to bending radius nominal, 45 degree and 90 degree.
  • Measure the output voltage through multi-meter between OUT and Ground pins or Use a microcontroller to measure the voltage output.

WORKING

Flex sensor are sensors that change in resistance depending on the amount of bend on the sensor. They convert the change in bend to electrical resistance the more bend the more the resistance value. They are usually in the form of a thin strip from 1”-5” long that vary in resistance. They can be made uni-directional and bi-directional.

Sizes -     1K     to     20K

               50K     to     50ohm

               50K     to      200k



flex-sensor

Sunday, March 1, 2015

MTECH SIMULATION LIST FOR EEE



S.No
TITLE
YEAR
1
A Carrier-Based Neutral Voltage Modulation Strategy for Multilevel Cascaded Inverters Under Unbalanced DC Sources
2014
2
A DC-Link Voltage Self-Balance Method for a Diode-Clamped Modular Multilevel Converter With Minimum Number of Voltage Sensors
2014
3
A Family of Neutral Point Clamped Full-Bridge Topologies for Transformerless Photovoltaic Grid-Tied Inverters
2014
4
An Effective Control Method for Quasi-Z-Source Cascade Multilevel Inverter-Based Grid-Tie Single-Phase Photovoltaic Power System
2014
5
Application of Series Voltage Boosting Schemes for Enhanced Fault Ridethrough Performance of Fixed Speed Wind Turbines
2014
6
Application of SHE-PWMfor Harmonic Immunity in VSCHVDCTransmission
2014
7
Cascade Cockcroft–Walton Voltage Multiplier Applied to Transformerless High Step-Up DC–DC Converter
2014
8
Control of a Bidirectional Converter to Interface Ultracapacitor with Renewable Energy Sources
2014
9
Control of Reduced-Rating Dynamic Voltage Restorer With a Battery Energy Storage System
2014
10
Control Scheme for a Stand-Alone Wind Energy Conversion System
2014
11
Control Strategies for AC Fault Ride Through in Multiterminal HVDC Grids
2014
12
Damping of SSR Using Subsynchronous Current Suppressor With SSSC
2014
13
Development and Implementation of a Simplified Self-Tuned Neuro–Fuzzy-Based IM Drive
2014
14
Dual Stator Winding Induction Machine Drive
2014
15
Dynamic Stability Improvement of Four Parallel-Operated PMSG-Based Offshore Wind Turbine Generators Fed to a Power System Using a STATCOM
2014
16
Excitation Synchronous Wind Power Generators With Maximum Power Tracking Scheme
2014
17
Flexible Reactive Power Control in Multigroup Current-Sourced HVDC Interconnections
2014
18
Flicker Mitigation by Individual Pitch Control of Variable Speed Wind Turbines With DFIG
2014
19
High efficiency and high power factor single-stage balanced forward-flyback converter
2014
20
Improved Active Power Filter Performance for Renewable Power Generation Systems Investigation of the Dynamic Stability of Microgrid
2014
21
Maximum Power Point Tracking Strategy for Direct Driven PMSG
2014
22
Modeling and Real-Time Simulation of Non-Grid- Connected Wind Energy Conversion System
2014
23
Modeling of Multi-Terminal VSC HVDC Systems With Distributed DC Voltage Control
2014
24
Modelling and Control Of Grid Interfacing Inverter for Voltage Unbalance Correction
2014
25
Modulation, Control and Capacitor Voltage Balancing of Alternate Arm Modular Multilevel Converter With DC Fault Blocking Capability
2014
26
Novel Comprehensive Control Framework for Incorporating VSCs to Smart Power Grids Using Bidirectional Synchronous-VSC
2014
27
Novel Dual-FCL Connection with Neurofuzzy controller for Adding Distributed Generation to a Power Distribution Utility
2014
28
Offshore Wind Integration to a Weak Grid by VSC-HVDC Links Using Power-Synchronization Control: A Case Study
2014
29
Power Flow Improvement In Transmission Line Using UPFC
2014
30
Optimal Decentralized Voltage Control for Distribution Systems With Inverter-Based Distributed Generators
2014
31
Power Optimization and Control in Wind Energy Conversion Systems Using Extremum Seeking
2014
32
Power Quality Improvement Using Single Phase D-Statcom in Wind Application
2014
33
Sliding-Mode-Control of CascadedMultilevel Inverter with Multiband Hysteresis Modulation Scheme
2014
34
Space Vector Pulsewidth Amplitude Modulation for a Buck–Boost Voltage/Current Source Inverter
2014
35
Study of Fault Current Characteristics of the DFIG Considering Dynamic Response of the RSC
2014
36
The Alternate Arm Converter: A New Hybrid Multilevel Converter With DC-Fault Blocking Capability
2014
37
Sub-Synchronous Interaction Damping Control for DFIG Wind Turbines
2014
38
Transformer-Less Series Reactive/Harmonic Compensation of Line-Commutated HVDC for Offshore Wind Power Integration
2014
39
A Two-Phase Interleaved Power Factor Correction Boost Converter With a Variation-Tolerant Phase Shifting Technique
2014
40
A New Interleaved Three-Phase Single-Stage PFC AC–DC Converter
2014
41
High-Conversion-Ratio Bidirectional DC–DC Converter With Coupled Inductor
2014
42
A Comparative Study of Two Buck-Type Three-Phase Single-Stage AC–DC Full-Bridge Converters
2014
43
Multiport Converters Based on Integration of Full-Bridge and Bidirectional DC–DC Topologies for Renewable Generation Systems
2014
44
An Autoground System for Anti-Islanding Protection of Distributed Generation
2014
45
Design and Implementation of Sensor less Capacitor Voltage Balancing
Control for Three-Level Boosting PFC
2014
46
Cascaded Two-Level Inverter-Based Multilevel STATCOM for High-
Power Applications
2014
47
VSC‐Based MVDC Railway Electrification System
2014
48
Design of Unified Power Quality Conditioner(UPQC)to Improve the Power Quality Problems by Using P-Q Theory
2014
49
Voltage Support Control Strategies for Static Synchronous Compensators Under Unbalanced Voltage Sags
2014
50
The Current Harmonics Elimination Control Strategy for Six-Leg Three-Phase Permanent Magnet Synchronous Motor Drives
2014
51
Transformer-Less Grid Feeding Current Source Inverter for Solar Photovoltaic System
2014
52
Partial-Resonant Buck–Boostand Fly back DC–DC Converters
2014
53
A Novel Control Method for Transformer less H-Bridge Cascaded STATCOM with Star Configuration
2014
54
An Adjustable-Speed PFC Bridgeless Buck–Boost Converter-Fed BLDC Motor Drive
2014
55
Design of a Sliding-Mode-Controlled SEPIC for PVM PPT Applications
2014
56
Current-Fed Interleaved Phase-Modulated Single-Phase Unfolding Inverter: Analysis, Design, and Experimental Results
2014
57
A Voltage-Controlled DSTATCOM for Power-Quality Improvement
2014
58
Zero Voltage Switching Technique for Bidirectional DC/DC Converters
2014
     59
An Integral Sliding-Mode Controller for Energy Efficiency Improvement in AC Power Source Supplied AC Machine Drives
2014
60
An Ultracapacitor Integrated Power Conditioner for Intermittency Smoothing and Improving Power Quality of Distribution Grid
2014
61
A Novel Transformer-less Adaptable Voltage Quadrupler DC Converter with Low Switch Voltage Stress
2014
62
Investigation of the Dynamic Stability of Microgrid
2014
63
New STATCOM control scheme for Power Quality improvement in wind farm
2014
64
Performance Analysis of Improved Power Quality Converter Fed PMBLDC Motor Drive
2014