Sunday, March 29, 2015

FLEX SENSOR



INTRODUCTION

The Flex Sensor patented technology is based on resistive carbon elements. As a variable printed resistor, the Flex Sensor achieves great form-factor on a thin flexible substrate. When the substrate is bent, the sensor produces a resistance output correlated to the bend radius—the smaller the radius, the higher the resistance value.


FEATUTRES

  • Size: approx 0.28" wide and 1"/3"/5" long
  • Resistance Range: 1.5-40K ohms depending on sensor. Flex point claims a 0-250 resistance range.
  • Lifetime: Greater than 1 million life cycles
  • Temperature Range: -35 to +80 degrees Celsius
  • Hysteresis: 7%
  • Voltage: 5 to 12 V

APPLICATION

  • gaming gloves
  • auto controls
  • fitness products
  • measuring devices
  • assistive technology
  • musical instruments and joysticks

SPECIFICATION

 parameter
 value
Operating Voltage
+5V DC regulated
Operating Current
100mA
Output
 Analog output
Flex Bending
Nominal,45 degree,90 degree


PIN DETAILS

Board has 3-pin connector for using the sensor. Details are marked on PCB.

Pin
Name
Details
1
GND
Power Supply Ground
2
+5V
Power supply Positive input
3
OUT
Analog output


USING SENSOR

  • Connect regulated DC power supply of 5 Volts. Black wire is Ground, Next middle wire is Brown which is output and Red wire is positive supply. These wires are also marked on PCB.
  • To test sensor you only need power the sensor by connect two wires +5V and GND. You can leave the output wire as it is.
  • The flex sensor analog resistors. They work as analog voltage dividers.
  • When the substrate is bend the sensor produces resistance output relative to bending radius nominal, 45 degree and 90 degree.
  • Measure the output voltage through multi-meter between OUT and Ground pins or Use a microcontroller to measure the voltage output.

WORKING

Flex sensor are sensors that change in resistance depending on the amount of bend on the sensor. They convert the change in bend to electrical resistance the more bend the more the resistance value. They are usually in the form of a thin strip from 1”-5” long that vary in resistance. They can be made uni-directional and bi-directional.

Sizes -     1K     to     20K

               50K     to     50ohm

               50K     to      200k



flex-sensor

No comments:

Post a Comment

Comment here....